OKS 1110/1 - Multi-Silicon Grease

Sealant and lubricant for cold and hot-water valves in plumbing and heating sector, in vehicle heating or cooling circuits, ground seals on glass taps and desiccators. For lubricating O-rings and rubber seals during assembly and operation, as well as plastic parts of all kinds.

Multi-Silicon Grease

Areas of applications

  • For best results, clean lubricant points and surfaces carefully, e.g. with OKS 2610 or OKS 2611
  • Apply grease evenly thin to the lubricant point (e.g. with a brush or spatula etc.)
  • Remove excess lubricant. Observe the instructions of the machine manufacturer
  • Relubrication intervals and amount to be defined acc. to the service conditions
  • Only mix with appropriate lubricants
  • Bearings filled with silicon grease must not have higher loads than 1/3rd of the bearing´s permitted load.
  • Silicone based plastics, e.g. silicone rubber, can be dissolved by silicone grease
  • Silicone grease must not be applied to sliding surfaces under influence of pure oxygen.
  • For further questions please contact our Technical department

Advantages and benefits

  • Highly effective due to excellent adhesion on all materials
  • Neutral behavior with regard to plastics and elastomers
  • Consistent properties without drying out, hardening or bleeding
  • Resistant to cold and hot water, as well as acetone, ethanol, ethylene glycol, glycerine and methanol
  • Toxicologically harmless as defined in Sec.31, Para. 1 of German Foodstuffs and Essential Commodities Act
  • Ingredients are acc. to FDA - instructions CFR 178.3570 approved for use in food processing industry

Technical specifications

Viscosity: +25⁰C @ 5000 mm2/s

Density: +20⁰C @ 1.0 g/ml

Applications

  1. Other

Industries

No matter what industry you come from, we at OKS have the right solution for you.

  1. Rubber and plastic processing
  2. Logistics
  3. Maintenance and servicing
  4. Automotive industry